Error Code 207
Error Code 207: SPED NOT DETECTED
Resolution:
1. Check the cable and connections from J7A on the docking board to the SPED board.
2. Power down the ATM in the proper sequence. From the Main Menu screen, select System Parameters (5) followed by Shut Down the Terminal (4). When the indication that it is safe to turn off the terminal is displayed on the screen push the Power ON/OFF switch to the OFF position. After about ten seconds, push the Power ON/OFF switch to the ON position to start the terminal.
3. Verify that the SPED board has the correct DC voltages applied to it.
4. If the DC voltages applied to the SPED board are correct and the cables are in good condition and seated properly, replace the SPED board.